https://doi.org/10.1140/epjp/s13360-025-06164-9
Regular Article
The study of high-efficiency pion production
1
Department of Physics, Graduate School of Science, Osaka University, 560043, Osaka, Japan
2
Institute of High Energy Physics, Chinese Academy of Sciences, 100049, Beijing, China
3
Spallation Neutron Source Science Center, 523808, Dongguan, China
4
High Energy Accelerator Research Organization (KEK), Tsukuba, Japan
5
Imperial College London, London, UK
Received:
15
October
2024
Accepted:
20
February
2025
Published online:
2
April
2025
An optimization study was conducted on low-energy pion production using a cylindrical tungsten target for the COMET Phase-II experiment, taking into account recent measurements of proton-beam emittance. The study suggests factor 1.6 of improvement in pion production efficiency by reducing the target radius down to 4 mm. This enhancement is attributed to the reduction in the emittance of the proton beam. Further increases in target radius simply reduce the yield of low-energy pions and, consequently, the stopping rate of low-energy muons in the muon stopping target. The analysis reveals that the pion production spectrum at higher momentum cannot compensate for the limitations imposed by the range–momentum curve of pions. There is a potential further improvement in low-energy pion production with an ideally narrow proton beam.
© The Author(s) 2025
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
