https://doi.org/10.1140/epjp/s13360-023-03991-6
Regular Article
Towards the development of a polymer-based assembly for cryogenic detectors for neutrino-less double beta decay
1
Istituto Nazionale di Fisica Nucleare, Sezione di Milano-Bicocca, Milan, Italy
2
University of Milano-Bicocca, Milan, Italy
3
Istituto Nazionale di Fisica Nucleare, Sezione di Roma1, Rome, Italy
4
Gran Sasso Science Institute, L’Aquila, Italy
5
Istituto Nazionale di Fisica Nucleare, GSGC, L’Aquila, Italy
Received:
18
November
2022
Accepted:
10
April
2023
Published online:
5
May
2023
Cryogenic single-particle detectors are devices, operated close to absolute zero, widely used in current and future generation detectors for the search for rare particle physics processes, for example neutrino-less double beta decay. Traditionally, these detectors are assembled in copper structures inside dilution refrigerators. The use of copper, however, is expected to become a limiting factor on the path towards the background reduction needed for future generation projects. Its high density and large Z make it an effective target where gamma-rays produced by radioactive contaminants can lose part of their energy undetected, and subsequently be measured as sensitivity-spoiling spurious signals in the region of interest of the energy spectrum. We present here a new method of building assemblies for kg-scale cryogenic single particle detectors based on low Z, low density additive manufacturing-compatible polymers that can in the future be doped with scintillating compounds thus making them an active component of the experimental setup. Additive manufacturing overcomes the limitations, imposed by traditional techniques, in the design of the structures. The assembly geometry can therefore be driven by the combined needs for reduction of mass and optimization of light production and collection. The experimental setup and the performance of the detectors in terms of energy resolution and temperature stability are described.
© The Author(s) 2023
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
